Table of Contents Previous entry (Q302) Next entry (Q304)

Q303: Tampermonkey says one of my scripts is blacklisted. Why?

A303 This happens cause you either added the source URL to the "Manual Userscript and @require Blacklist" or it was added to the list maintained by me. You can find the list including the reason for blackisting at the GitHub repo.

If you still want the script to run then you can either increase the "Severity Level" or disable the remote list this way:

• Go to the options page
• Make sure "Config Mode" is set to Beginner or higher
• Scroll down to the "BlackCheck" section
• Modify the "Blacklist Source" or "Severity Level"

Note: If you're a script author and think I made a mistake, then just send me an email or open an issue at GitHub.